The rally is your squad’s most important asset. It keeps momentum up and saves you a 300 m run back to where the fight is.
Much of the game is about burning enemy rallies and pushing them back, so sometimes holding fire and going for the rally burn is the better play.
Key numbers
Section titled “Key numbers”- 50 m: cannot place a rally if an enemy is inside
- 35 m: rally sound audible
- 30 m: enemy inside = rally burned
Faction differences
Section titled “Faction differences”- Canadian Resistance Forces: squad leaders get 3 rallies instead of one.
- Insurgents, the buddy rally: a dead squad leader can place their rally next to another squad leader’s rally. In the deployment menu, right-click a friendly rally (on PC) and pick Deploy Rally Point. Two players who sneak behind the enemy line and set one rally can open the way for a large force. Move the new rally as soon as you can, so one burn doesn’t take out both.
Burning enemy rallies
Section titled “Burning enemy rallies”A rally burns the moment an enemy gets within 30 m of it. You don’t have to find it, see it or shoot it: just walk past. Every rally you burn sends that squad’s next spawn back to a HAB or their main.
- Who: LATs have the fewest squad duties, so they make ideal rally burners. A rifleman playing on the edge of the squad can go too.
- Agree it with your SL first. While you are burning, you aren’t fighting with your squad.
- Take a wide flank, well away from the fighting
- Hide in bushes and let enemies run past you
- Call every rally you burn, and where it was
- Take fights. One kill gives away where you are, and the rallies are worth more
Walk a zigzag
Section titled “Walk a zigzag”Rallies sit somewhere behind the enemy line, but you never know how deep. Walk straight along the line and you only check a 60 m wide strip. Zigzag instead: cut in deep, come back towards the line, then cut in deep again. Your burn zone sweeps a far deeper band behind the enemy for only a little more walking.
- Your route: round the flank, then zigzag
- Burn zone: 30 m either side of you
- Enemy rally, burned when you pass within 30 m
- Enemy front line
Spawn timing
Section titled “Spawn timing”Every rally spawns on a fixed second of each minute. You must be dead 20 seconds before the wave, or you’ll see that nasty 75-second wait. Give up a few seconds before that, to allow for the death animation and choosing the rally.
Rally comms
Section titled “Rally comms”When a rally goes up, post its spawn second in chat right away. The SL who placed it should do this immediately, or on first spawning there.
- squadSL 3“xx:17”
- teamSL 3“R3 xx:17”
- squadRifleman“Rally in twenty.”
- While you wait for the timer, call “Rally in 20” or “Rally in 40” so downed teammates can decide whether to give up.
- Rally burned? Call it out and put a helmet marker on the old rally spot.
The team chat post (R3 xx:17) helps HATs and anyone joining from another squad.
Rally scanning
Section titled “Rally scanning”An SL trick for checking whether an enemy is still hiding in a bush or compound nearby.
You need: the SL kit · no friendlies within 15 m (so you don’t actually place it) · the rally not on cooldown.
- Try to place a rally.
- No enemy nearby: you get “You need at least 1 squad member nearby…”
- Enemy within 50 m: you get “Unable to deploy a Rally point. Hostile forces nearby.”
Rally hopping
Section titled “Rally hopping”Rally hopping is used to defend a HAB or objective in a tight spot, or to reinforce a raid behind enemy lines.
- 1Give up
Once you are dead.
- 2Leave
Leave your squad.
- 3Join
Join the target squad.
- 4Same kit
Same kit and scope variant, so you get your ammo back.
- 5Spawn
On their rally or HAB.
- 6Return
Rejoin your squad when your SL calls you back or the job is done.
